Preparation; Before Switching On Your Tv; Power Connection; Connections To The Rf Input Socket - JVC InteriArt AV-28E50SK Instructions Manual

Preparation

For ventilation, leave a space of at least 10 cm free all
around the set. To prevent any fault and unsafe situa-
tions, please do not place any objects on top of the set.
Use this apparatus in moderate climate.

Before Switching on your TV

Power connection

IMPORTANT: The TV set is designed to operate on 220-
240V AC, 50 Hz.
• After unpacking, allow the TV set to reach the ambi-
ent room temperature before you connect the set to
the mains.

Connections to the RF input socket

• Connect the aerial or cable TV plug to the RF input
socket located at the back of the TV and connect the
cable plug coming out from the TV out socket located
at the devices (VCR, DVB etc.) to this socket as well.

+)8+)
WÃS@6SÃQ6I@G

How to connect other devices

IMPORTANT: Switch off the TV before connecting any
external device.
Sockets for external connections are at the back and
right side of the TV. For connection of other devices via
Euroconnector refer to the manuals of the related de-
vices.
67G@ÃUWÃ
- 6 -

Inserting batteries into the remote control

• Remove the battery cover located on the back of the
remote control by gently pulling downwards from the
indicated part.
• Insert two AA (R06) or equivalent type batteries in-
side. Place the batteries in the right directions as seen
below.
• Replace the battery cover.
NOTE: Remove batteries from remote control when it is
not to be used for a long period. Otherwise it can be
damaged due to any leakage of batteries.

Switching the TV ON/OFF

To switch the TV on

Your TV will switch on in two steps:
1- Press the power button located on the front of the
TV. Then the TV switches itself to standby mode and
the power lamp becomes RED located on the lower
part of the TV.
2- To switch on the TV from stand-by mode either:
 ,
Press the “ ” button on the remote control,
or,
Press a digit button on the remote control so that a
programme number is selected,
or,
Press Programme Up or Down buttons on the right side
of the TV or on the remote control, so that last switched
off programme is selected.
The TV will switch on and the power lamp will turn off.

To switch the TV off

• Press the stand-by button on the remote control, so
the TV will switch to stand-by mode and the power
lamp will become RED,
or,
• Press the power button located on the front of the TV,
so the TV will switch off and the power lamp will turn
off.