Table of Contents
Advertisement
WARNING
•
Before operating a lifter, this manual must be read and understood.
•
Always apply brakes to the rear wheels when loading and unloading.
•
NEVER exceed the indicated max load capacity on the lifter.
•
Make sure to load according to the load diagrams including y-distances. See Labels on TAWI Light
trolley and Loading on page 7-8.
•
Make sure loads are distributed evenly on the platform and always load according to load diagram.
•
If any unexpected movement of the lifter occurs, press emergency stop.
•
In case of emergency, engage the emergency stop, see Operating panel on page 15.
•
Make sure to control and solve any potential errors before resetting the emergency stop.
•
The operator's position should always be behind the lifter when it is used. From this position the
emergency stop is within reach.
•
Stay clear of the area underneath a tool at all times.
•
Stay clear of moving parts.
•
During all service and maintenance, lay the lifter down on the floor (on its back).
•
In order to deal with the lifter's cables and wiring, a good knowledge of electricity and TAWI elec-
trical schedules of the lifters is required. Faults can cause damage to people and property.
•
NEVER climb on the lifter.
•
NEVER stand on the cover or any other part of the lifter.
•
It must never be used to lift living humans or animals.
Caution
•
The lifters are made for indoor use on a smooth, even floor/surface. Max allowed inclination is 4%.
•
The recommended temperature range for the lifters is 10 - 50°C (50 - 122°F). The lifting performance
may vary when the temperature deviates from 20°C (68°F).
•
Make sure there is good lighting in areas where the lifter is operated.
•
Use caution when passing over thresholds, floor drains, hoses or cables.
•
Never spray or pour water onto the casing containing the battery, charger and motor. Clean with a
damp cloth only.
•
Recharge the battery in a designated dry area.
•
Any part of this lifter or accessories that show signs of wear or other damage must be replaced
immediately. The lifter must not be used before the damaged part is replaced.
•
Do not use the lifter while it is plugged into an outlet.
•
Only run the lifter when it is completely assembled.
•
Wear steel toe shoes with good grip when operating the lifter.
•
NEVER adjust the limit switch setting on the limit switch module.
Page 05
Advertisement
Table of Contents
