Changing The Screen Settings - Sony ICF-DVD57TV Operating Instructions Manual

Changing t he screen
set t ings
You can adjust the screen settings manually if
the screen is hard to see from your position.
1
Press TV M ENU.
The "PICTURE" screen appears.
Each time you press TV CH/PRESET –,
.(Previous) or +, >(Next) [TUNE/CH
– or +], the setting screen changes in the
following sequence:
TV
2
Press ENTER to adjust to the desired
setting.
PICTURE: Press TV CH/PRESET +,
>(Next) [TUNE/CH +] to
increase the contrast. Press TV
CH/PRESET –, .(Previous)
[TUNE/CH –] to decrease
contrast. Press ENTER to enter the
setting. (Default value: 32)
30
Downloaded from:
DVD
AUX
The setting value of
the item selected
appears in this area.
https://www.usersmanualguide.com/
BRIGHTNESS:
TV CH/PRESET +, >(Next)
Press
[TUNE/CH +]
to brighten the picture.
TV CH/PRESET –, .(Previous)
Press
[TUNE/CH –]
to darken the picture.
Press ENTER to enter the setting.
(Default value: 30)
TV CH/PRESET +, >(Next)
COLOR: Press
[TUNE/CH +]
to increase color
saturation. Press
(Previous) [TUNE/CH –]
color saturation.
the setting. (Default value: 32)
HUE: TV CH/PRESET +, >(Next)
Press
[TUNE/CH +]
to increase red tones. Press
TV CH/PRESET –, .(Previous)
[TUNE/CH –]
to decrease the green tones.
Press ENTER to enter the setting.
RESET: You can reset the PICTURE, BRIGHTNESS,
COLOR and HUE settings to the factory
TV CH/PRESET –,
setting. Press
.(Previous) or +, >(Next) [TUNE/
CH – or +]
to select "YES."
Press ENTER to enter the setting.
CABLE: Press TV CH/PRESET –, .(Previous)
or +, >(Next) [TUNE/CH – or +]
select one of the following options.
ON : Select if you are receiving cable
channels with a CATV cable.
OFF : Select if you are using a TV antenna.
Press ENTER to enter the setting.
TV CH/PRESET –, .(Previous)
MTS:
Press
or +, >(Next) [TUNE/CH – or +]
select one of the following options.
STEREO : Select when viewing a broadcast in
stereo.
MONO : Select to reduce noise in areas of
poor reception.
AUTO SAP : Select to have the TV
automatically switch to a second audio
program(SAP) when a signal is received.
Press ENTER to enter the setting.
AUTO PROGRAM:
TV CH/PRESET –, .(Previous)
Press
or +, >(Next) [TUNE/CH – or +]
select "YES," then press ENTER. The TV
will scan through all available channels
and program receivable channels.
CHANNEL SKIP/ADD:
Select whether a channel is skipped or
displayed when
(Previous) or +, >(Next) [TUNE/CH
– or +]
is pressed.
Select CHANNEL by
.(Previous) or +, >(Next)
[TUNE/CH – or +]
ENTER.
When you want to skip the channel, press
TV CH/PRESET –, .(Previous) or +,
>(Next) [TUNE/CH – or +]
SKIP and then press ENTER.
When you want to display the channel,
select ADD in the procedure mentioned
above.
TV CH/PRESET –, .
to decrease
Press ENTER to enter
to
to
to
TV CH/PRESET –, .
TV CH/PRESET –,
and then press
, display