Set t ings for digit al audio
out put
— AUDIO SETUP
A U D I O
S E T U P
D O W N M I X
D I G I T A L
D R C
S E L E C T : < , , E N T E R Q U I T : S E T U P
♦
DOWNM IX
You can select the downmix mode from
"Surround" or "Normal". The downmix
function is used to create stereo (2-channel)
signals from more than 5 separated digital
signals of a source. This setting affects the
outputs of OPTICAL OUTPUT.
SURROUND Normally, select this position.
Multi-channel audio signals are
output to 2 channels for enjoying
surround sounds.
NORMAL Multi-channel audio signals are
downmixed to 2 channels for use
with your stereo.
♦
DIGITAL OUTPUT
You can set the mode of the audio signals
output from the OPTICAL OUTPUT
connector.
RAW
Select this when you connect an
audio component with a built in
Dolby Digital decoder or DTS
decoder.
PCM
Select this when you connect an
audio component without a
built-in Dolby Digital decoder or
DTS decoder. The downmix signal
is output.
OFF
No signal is output from OPTICAL
OUTPUT connector.
26
Downloaded from:
O U T P U T
https://www.usersmanualguide.com/
Notes
• When " OFF" is select ed, no signal is out put f rom
t he OPTICAL OUTPUT connect or.
• When you connect t he player and a digit al
recording device such as an M D player t hrough
an opt ical cable t o record t he CD cont ent s w it h
t hat device, t he cont ent s w ill be recorded as one
cont inuous t rack.
• If noise occurs in peripheral equipment w hen
using DIGITAL OUTPUT, select " OFF" t o t urn of f
DIGITAL OUTPUT.
• Sampling sound of 96kHz is changed t o 48kHz.
• If t he sound set t ing is changed t o DTS by t he
AUDIO but t on or Disc menu, no sound is emit t ed
f rom t he speaker.
• When you connect t o anot her unit w hich does
not support t he DTS f unct ion and change t he
sound set t ing t o DTS, noise may occur. In t his
case, change t he audio set t ing t o ot her t han DTS.
• While t he playing back a CD, w het her t he
DIGITAL OUTPUT is set t o RAW or PCM , t here is
no dif f erence in t he audio ef f ect .
♦
DRC (Dynam ic Range Cont rol)
Makes the sound clear when the volume is
turned down when playing a DVD that
conforms to "Audio DRC". You can set the
DRC level from 9 steps (including "OFF"). This
setting affects the outputs of OPTICAL
OUTPUT.
MAX: Makes the low sounds clear even if you turn
the volume down.
OFF: Set to enjoy the dynamic sound.