Table of Contents
Advertisement
HT-S870_En.book Page 51 Monday, September 13, 2004 5:15 PM
Advanced Setup —Continued
3
While the Subwoofer setting is
selected, use the Left and Right
[
]/[
] buttons to select Yes or
ENTER
No .
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
4
Use the Down [
select "Front," and then use the
Left and Right [
ENTER
select Small-THX or Large .
Small: Select if the front speakers are
small.
Large: Select if the front speakers are
large.
ENTER
Note:
• If the Subwoofer setting in step 3 is
set to No, this setting is fixed at Large
and does not appear.
5
Use the Down[
select "Cntr," and then use the
Left and Right [
ENTER
select Small-THX , Large , or
None .
Small: Select if the center speaker is
small.
Large: Select if the center speaker is
ENTER
large.
None: Select if no center speaker is
connected.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
6
Use the Down[
select "Surr," and then use the
Left and Right [
ENTER
select Small-THX , Large , or
None .
Small: Select if the surround left and
right speakers are small.
Large: Select if the surround left and
ENTER
right speakers are large.
None: Select if no surround left and
right speakers are connected.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
7
] button to
]/[
] buttons to
8
] button to
To test that all of your speakers are working properly,
press the remote controller's [TEST TONE] button.
]/[
] buttons to
The test tone will be output by each speaker in turn
and the name of each speaker will appear on the dis-
play. To turn off the test tone, press the [TEST
TONE] button again.
• If the test tone is not produced by a speaker, or it's
produced by a speaker other than that shown on the
display, you may have wired your speakers incorrectly
and you should check your connections (see page 19).
• If the test tone is not produced by a speaker and its
name does not appear on the display, you may have set
the speaker settings incorrectly (see page 50).
] button to
]/[
] buttons to
Use the Down [
select "SurrB," and use the Left
and Right [
]/[
ENTER
select Small-THX , Large , or
None .
Small: Select if the surround back
speaker is small.
Large: Select if the surround back
ENTER
speaker is large.
None: Select if no surround back
speaker is connected.
Notes:
• If the Surround setting in step 6 is set
to None, this setting does not appear.
• If the Surround setting in step 6 is set
to Small, the Large option cannot be
selected.
Press the [SETUP] button.
Setup closes.
] button to
] buttons to
51
Advertisement
Table of Contents
