Table of Contents
Advertisement
List e ning t o t he ra dio
(c ont inue d)
1
Press TUNER/BAND repeatedly to
select FM or AM.
2
Press . or > repeatedly or use the
numeric buttons to tune in the desired
preset station.
When you directly tune in a preset number
over 10, press >10 first, then press the
corresponding number buttons. (e.g. To
select 20, press >10, 2, and then 10/0.) 10/0
is the button to input 10 or 0.
* When only one station is preset, "ONE PRESET"
appears in the display.
To
Turn off the radio
Adjust the volume
60
Downloaded from:
Preset number*
Frequency
Do this
Press ?/1.
Press VOL +/–.
https://www.usersmanualguide.com/
T o list e n t o non-pre se t ra dio
st a t ions
Use manual or automatic tuning in step 2. For
manual tuning, press m or M repeatedly. For
automatic tuning, press and hold m or M.
T ips
• Pressing TUNER/BAND when the power is off
automatically turns the power on and tunes to the
last received station (One Touch Play). When the
system is in the Power Saving Mode, the One
Touch Play function does not work.
• You can switch from another source to the radio
just by pressing TUNER/BAND (Automatic Source
Selection).
• When an FM program is noisy, do the following
procedure:
1 Press MODE SELECT repeatedly to select "Set
Up Mode", then press ENTER.
2 Press B or b repeatedly to select "TUNER Set
STEREO
Up ?", then press ENTER.
3 Press B or b repeatedly to select "Stereo
Mono ?", then press ENTER.
4 Press B or b repeatedly to select "Mono", then
press ENTER.
"Mono" appears in the display.
There will be no stereo effect, but the reception will
improve. To restore the stereo effect, repeat steps 1
through 4 and select "Stereo" in step 4.
• To improve broadcast reception, reorient the
respective antenna.
N ot e s
• When the TUNER function is selected, there is no
display on the TV screen.
• When DVD is selected as the current function and
TUNER/BAND is pressed to select the TUNER
function, some time may be necessary before the
function can be switched.
• When you change the function from DVD to
TUNER, "WAIT!" may appear on the front panel
display. While this appears, there is no audio
output.
Advertisement
Table of Contents
