Inel PIL-99TST Original Instructions

PIL-99TST remote control with color touch screen

– on / wake-up button

– USB-C port for
battery charging
1 Registration of remote control channels
to the receiver (drive, controller)
Control of any channel from the remote control is
possible after registering this channel to the given drive
or controller.
In our devices we distinguish the following ways to
enter the recording option:
o First registration after switching on the supply
voltage (230 V mains-powered radio drive, ST-
01RL),
o First registration for radio drive supplied with
DC (LER)
o Registration to ST-01R controller,
o Registration with a pre-programmed remote
control (radio drive, ST-01RL, ST-01R).
1.1 First registration for 230 V mains-powered
radio drives and ST-01RL controllers
NOTE: The procedure will erase from the
drive's memory all remote controls that
were previously registered.
•
Connect the 230 VAC supply voltage to the
drive/controller.
•
Within 10 seconds of power on, touch the
programming button of the remote control, the
shutter will make an up and down movement.
•
In the next 10 seconds, touch the
the selected remote control channel; a short up
and down movement will confirm that the
registration is correct.
Original instructions EN
PIL remote control operating instructions
Model: PIL-99TST
button on
1.2 First registration for DC radio drives (LER)
In the case of a drive received from the manufacturer,
or if the remote control is lost, register the remote
control using the following procedure:
•
press the SW button on the drive head for a short
time (< 2 seconds) – the drive will make a short
up-down movement
•
within 10 seconds, select the desired channel on
the remote control
programming button on the remote control – the
drive will make a short up and down movement
•
within the next 10 seconds, touch the
of the remote control – the drive will confirm the
channel registration by making a long up-down
confirmation movement
1.3 Programming the ST-01R controller
•
press programming button S1 on the controller –
the LED will blink and remain lit with a
continuous green light
•
select the desired channel on the remote control
•
touch the button on the remote control; the
controller will signal the registration of the
remote control by blinking green and red LEDs
1.4 Once you have a registered remote control
Once you have a registered remote control, you can
register further remotes without powering off.
Using a pre-registered remote control, put the
drive/controller into programming mode:
•
touch the
registered channel of the PIL-99TST remote
control; the shutter will make an up and down
movement, followed by a series of short up and
down movements in an amount equal to the
number of registered remote controls,
•
within the next 10 seconds, touch the
button of the new channel or the new remote
control
1.5 Changing the direction of the shutter
movement
If it is necessary to change the direction of movement
of the shutter (the movement of the shutter is opposite
to the directions on the remote control), put the drive
into programming mode by touching the
programming button of the remote control, and then
touch the button. In RE and PR and LER
motors, this operation should be performed twice.
and touch the
button
programming button of the
"up"