Inel PIL–19DLT Operating Instructions

OPERATING INSTRUCTIONS - PIL–19DLT/PIL-99DLT multi-channel remote control
Number of selected channel
1. STARTING ROLLER BLINDS
To start the given drive, press the
or the "down" button (to close). You can stop the drive
by pressing the "stop" button at any time. After
approximately 15 seconds of inactivity (no button pressed)
the remote will switch into "standby" mode (low battery
power consumption). The remote is in "standby" mode as
standard. Pressing any directional button will wake it and
prepare it to work (it will display channel number, but no
other operation will be performed). The command will only
be executed after pressing the button the second time.
2. SELECTING CHANNEL
2.1.
In the PIL-19DLT remote channel is selected by short
pressing the "minus" button (decrease channel
number) or the
number).
2.2.
In the PIL-19DLT remote you may select the number
of an individual channel (01-99). Proceed as follows:
2.2.1.
99
"minus"
modification of the left digit (tens) -
the
displayed next to the digit. Modify the
digit by pressing the
18.09.16 13.27
"down" buttons. Pressing the
"minus" button the second time will
end digit modification.
2.3.
Short pressing the + "plus" button will enter the
modification of the right digit (units) - the
down" arrow will be displayed next to the digit. Modify
the digit by pressing the
buttons. Pressing the
time will end digit modification.
1 | P. I. E. INEL Sp. z o. o., ul. Mostowa 1, 80-778 Gdańsk,
inel@inel.gda.pl
Active timed programmes
45
mm
"up" button (to open)
"plus" button (increase channel
Short pressing the
button will enter
"up-down" arrow will be
"up" or
"up" or
"plus" button the second
Active blind mode
Executed command
Date and time
Back of the
remote, under
2.2.3.
If no digit is currently being modified, then the
command to open, close or stop to a single
controller or group.
2.2.4.
In order to turn the limited mode on/off in the
PIL-99DLT remote you must change the
operation mode in the remote menu. "S" will be
displayed, followed by the highest used channel
number.
Channel 00 in the PIL-19DLT and PIL-99DLT remotes
controls all roller blinds at the same time (no need to
register, after registering an individual channel).
3. STARTING THE SHUTTER MODE
To switch into the shutter mode (positioning fins) press
and hold the
approx. 3 seconds. Three horizontal lines will be displayed
next to the channel number. To turn fins press the
or "down" button. Returning to normal operation mode
is done similarly - press and hold the
"minus" button.
the
WARNING: In order to set the shutter fins, the shutter
must be stopped. If the fins cannot be set from the remote,
press the
"up-
"down"
"up" button
"stop" button
"down" button
"plus" button
"minus" button
"clock" button
"menu" button
, and STOP buttons will send the
"plus" button or the
"STOP" button and try again.
www.inel.gda
.pl
"minus" button for
"up"
"plus" or