Fnirsi HS-01 User Manual page 21

6.Operating Instructions
●Power on:Power on when connected to the power supply, the screen displays the boot icon,
displays a prompt to insert the soldering iron tip
tip is inserted
●Heating:
280
heating page
℃
10%
●One-key standby：
28 0
10%
standby page
●Temperature setting:
setting page to set the temperature,
button to decrease a step value. Long press to increase or decrease quickly, the step is 10°C or 20°F.
●Setting mode:In the non-temperature setting page, press and hold the left and right keys at the same time to enter
the setting mode
Vol Select
Birghtness
●Screen brightness:In the setting mode, short press the left and right keys to switch to brightness
long press the right key to enter
.
The icon button will flash, then short press the corresponding physical button to enter the
, and the soldering iron will heat up.
20V
SET
2 80
Long press the right button on the heating page to turn off the heating and return to the
2 0V
SE T
℃
2 8 0
.
280
In the heating page state, press the left and right keys to enter the temperature
10%
℃
2 80
280
S ET
℃
8 0 42 0
.
Calibrate
, and the left and right keys adjust, and long press any key to exit.
, The interface will be displayed after the soldering iron
short press the right button to add a step value, short press the left
15
and then
,
Vol Select Birghtness Calibrate