JVC UX-A52R Service Manual page 22

UX-A52R
<Cassette mechanism section>
CAUTION: Prior to
procedures, turn the mode gear in the
direction of the arrow to move each section
to the eject position.
Removing the side bracket (L) and (R) /
load board (See Fig.1 to 4)
1. Remove the E-washer attaching the load arm on the
right side of the body.
2. Turn the load arm in the direction of the arrow to
release from the cassette hook at the joint a.
3. Remove the spring (1) attaching the trig lever.
4. Move the trig lever in the direction of the arrow and
release it from the two holes b.
5. Remove the screw A attaching the load board on
the right side of the body and unsolder the wire
extending from the sub motor.
REFERENCE: The side bracket unit (R) can be
removed even if the load board is
attached. In such case, make sure to
unsolder the wire extending from the
sub motor.
6. Remove the spring (2) and the holder collar on the
right side of the body.
7. Remove the two screws B
bracket unit (R) in the direction of the arrow.
8. Remove the four screws C
bracket (L) in the direction of the arrow.
1-22
performing the following
attaching the side
attaching the side
Joint a
Fig.1
Slide bracket
Fig.2
Soldering
A
Fig.3
Cassette hanger assembly
C
Side bracket unit (L)
C
C
Side bracket unit (R)
B
Fig.4
Load arm
E-washer
Load arm
Hole b
Hole b
Spring (1)
Load board
C
B
Spring (2)
Holder collar