HomeMatic HmIP-WGD Installation And Operating Manual page 32

Start-up
• After connecting the power supply, the device is active for 3 min-
utes.
You can manually start the pairing mode for another 3 minutes by
pressing the system button (D) briefly using a pointed object (e.g. a
pen) (see figure 8).
• Wait until pairing is completed.
• If pairing was successful, the LED (D) lights up green. The device
is now ready for use.
• If the LED lights up red, please try again.
• After a short time, the newly added device will appear in the in-
box of your software interface.
Newly connected devices and the corresponding channels are ready for
operation and configuration only after they have been configured in the
inbox. You will find further information in the Homematic IP Wired Instal-
lation Guide at www.homematic-ip.com.
For operating without an Internet connection, please select the op-
tion "Adding Homematic IP device without Internet connection".
Enter the SGTIN and key of the device into the corresponding fields.
You will find the SGTIN and the key on the supplied sticker. Keep the
sticker in a safe place.
32