Installation; Pairing - HomeMatic HmIP-WGD Installation And Operating Manual

Start-up
5.2

Installation

The bus is powered by the Homematic IP Wired Access Point (HmI-
PW-DRAP). For further information, please refer to the operating
manual of the corresponding Wired Access Points.
To facilitate connection to the terminals, the green push-in terminal
can be removed from the device. To do this, release the mounting
plate, press the latch on the back next to the lock symbol and slide
the clamp out of the mounting plate to the side (see figure 2).
For the installation, please proceed as follows:
• Disconnect the corresponding line of the incoming Homematic
IP Wired bus (see figure 3).
• Connect the Homematic IP Wired bus to the bus connecting ter-
minals (see figure 4). To connect and loosen the individual wires,
press the orange clamp using a small screwdriver.
Place the mounting plate (A) in the flush-mounted box and fas-
•
ten it to the box using the screws supplied (see figure 5).
• Place the display (B) in the mounting plate by fully engaging the
connecting pins in the mounting plate bracket provided for this
purpose (see figure 6).
• Switch on the Homematic IP Wired bus again (see figure 7) to
activate the device's pairing mode (see „5.3 Anlernen" auf Seite
30).
5.3

Pairing

Please read this entire section before starting the pairing proce-
dure.
Please refer to the Homematic IP Wired System Manual for detailed
information on setup and control options.
To integrate the device into your system and enable it to communicate
with other devices, you must first add it. The following set-up and control
options are available:
30