Start-Up; Installation Instructions - HomeMatic HmIP-WGD Installation And Operating Manual

Start-up

functions provided by the system in combination with other components
are described in the Homematic IP Wired User Guide, available for down-
load. All current technical documents and updates are provided at www.
homematic-ip.com.
5 Start-up
5.1

Installation instructions

Since the bus is powered by the Homematic IP Wired Access Point
(HmIPW-DRAP), you must first set-up a Homematic IP Wired Access
Point (HmIPW-DRAP) to enable power supply for the device.
Before installation, please note the device number (SGTIN) labelled
on the device as well as the exact application purpose in order to
facilitate later allocation. You can also find the device number on the
QR code sticker supplied.
Installation may only take place in normal commercial switch boxes
(device boxes) in accordance with DIN 49073-1.
Please note the insulation stripping length of the conductor to be
connected, indicated on the device.
Please observe the hazard information in section „2 Gefahrenhinwei-
se" auf Seite 25 during installation.
Please note! Only to be installed by persons with the relevant elec-
tro-technical knowledge and experience!*
Incorrect installation can endanger
• your own life,
• and the lives of other users of the electrical system.
Incorrect installation also means that you are running the risk of serious
damage to property, e.g. from fire. You risk personal liability for personal
injury and property damage.
Consult an electrician!
28