Table of Contents
Advertisement
STANDBY/ON
TIMER
REC LINK
TEST SIGN AL
Downloaded from:
https://www.usersmanualguide.com/
DISPLAY
TV PROG
1
2
3
2
4
5
6
7
8
9
0
4
TV PRO G
1
?
O K
The channel on which the screen on
the left appears clearly in step 2 is
your Video Channel.
W ith RF Connection
Before performing the following procedure, make
sure that:
the mains power cord is plugged into the mains outlet.
the video recorder is turned off and there is no cassette
inserted in the recorder.
the connected TV is turned on.
batteries have been installed in the remote control.
ACCESS VIDEO CHAN -
N EL SET MO DE
1
Press and hold down STO P on the recorder until the
display panel shows the following.
SET VIDEO CHAN N EL
2
Press TV PROG+ or – to set the video recorder to a vacant
channel between 22 and 69 which is not occupied by any
local station in your area. Refer to list on page 36 for
details of broadcast stations in your area.
(Ex.) If channel 36 is available in your area
Then set your TV to UHF channel 36. (Refer to the
instructions supplied with your TV set for how to do
this.)
If the two vertical white bars appear clearly on the
screen as shown in the illustration at bottom left, go to
step 3 .
If the two vertical white bars do not appear clearly, re-
set the video recorder to another vacant channel and
try again.
IM PO RTAN T
If you set the video recorder to a channel which
is occupied by a local station or has
neighbouring channels that are occupied by
local stations, the picture reception quality will
be affected and some interference noise will
appear on the TV screen. Be sure to select a
vacant channel which has no broadcast on
neighbouring channels.
If you cannot obtain the two vertical white bars
clearly with any channel between 22 and 69,
consult your J VC dealer.
EXIT VIDEO CHAN N EL SET
M O DE
3
Press O K .
To view picture signals from the video recorder, set your
TV to the Video Channel.
29
Advertisement
Table of Contents
