Table of Contents
Advertisement
28
V ideo
Cha nnel Set
Video Channel (RF Output Channel) is the channel on
which your TV receives picture and sound signals from the
video recorder through the RF cable.
STANDBY/ON
TIMER
REC LINK
Downloaded from:
https://www.usersmanualguide.com/
DISPLAY
TV PROG
1
2
3
2
4
5
6
7
8
9
0
4
TV PRO G
1
?
O K
SU BSID IARY SETTIN GS
IM PO RTAN T
Perform the following steps only if —
— Video Channel Set has not been done correctly by the
Auto Set Up function (
— interference appears in the TV picture after you have
moved to a different area or a new station has started
broadcasting in your area.
— you change the connection between your recorder and
TV from RF connection to AV connection, or vice versa.
If you have connected the video recorder to
your TV via both an RF cable and a 21-pin
SCART cable (AV connection), you do not need
the video channel so you have to set the video
channel to off. — Go to "W ith AV Connection"
below.
If you have connected the video recorder to
your TV via an RF cable only (RF connection),
you have to set the correct video channel — Go
to "W ith RF Connection" on page 29.
W ith AV Connection
Before performing the following procedure, make
sure that:
the mains power cord is plugged into the mains outlet.
the video recorder is turned off and there is no cassette
inserted in the recorder.
batteries have been installed in the remote control.
ACCESS VIDEO CHAN -
N EL SET MO DE
1
Press and hold down STO P on the recorder until the
display panel shows the following.
SET VIDEO CHAN N EL
2
Press TV PRO G – until the display panel shows
" – OUT – – ".
Now the video channel is set to off.
EXIT VIDEO CHAN N EL SET
M O DE
3
Press O K .
To view picture signals from the video recorder, set
your TV to its AV mode. Refer to the instructions
supplied with your TV set for how to do this.
pg. 6).
Advertisement
Table of Contents
