Accessories; Accessories And Connections; Accessory Connections - Kohler KD700 Operation

4.1

Accessories and Connections

Factory-installed accessories are available to help finalize installation, add convenience to operation and service, and establish
state and local code compliance.
See Figure 89 for a list of available kits. Obtain the most current accessory information from your local authorized service
distributor/dealer.
Kit Description
Battery Chargers
Analog Input/ Output Module
Digital Input/ Output Module
Thermocouple Input Module
Remote Emergency Stop
Remote Serial Annunciator
Figure 89 Optional Accessories
This section illustrates several accessories available at print time of this publication. Accessory kits generally include installation
instructions. See wiring diagrams manual for electrical connections not shown in this section. See the installation instructi ons
and drawings supplied with kit for information on kit mounting location.
The instructions provided with the accessory kit supersede these instructions where there are differences. In general, run AC
and DC wiring in separate conduit. Use shielded cable for all analog inputs. Observe all applicable national, state, and local
electrical codes during accessory installation.
See the Accessory Connections section, and the generator set wiring diagrams for terminal identification.
4.2

Accessory Connections

Connect external optional accessories including alarms, battery chargers, thermocouples, and remote switches to the terminal
block or modules in the customer connection box. See Figure 90. Do not attempt to connect directly to the APM802 controller
or base module.
For specific information on accessory connections, refer to the accessory wiring diagrams in the wiring diagram manual and th e
instruction sheet accompanying the kit. See the generator set wiring diagram for TB10 c onnections.
Note:
Covers have been removed for illustration.
Figure 90 APM802 Controller and Customer Connection Box
TP-7070 11/22
Section 4. Accessories
USB port (under hinged panel)
240 VAC/60 Hz power supply connection
Terminal block TB10 for accessory connections
Optional module locations
11601000945
79