Jump-Starting Procedure - Smartech TECH-5000P User Manual

JUMP STARTING PROCEDURE
1. This unit is only for emergency use, not for frequent commercial
use! ENGINE START socket is ALWAYS activated! Do not attempt
to jumpstart your vehicle when the TECH-5000P Power Bank
battery capacity is below 30%.
2. Turn off the vehicle ignition and all accessories (radios, lights, air
conditioners, etc.), and disconnect electronic devices.
3. Connect the jumper clamps to the correct polarity battery terminals
as per item 3 in the previous CONNECT TO BATTERY section.
4. Connect the EC5 plug of jumper cables to the ENGINE START
socket of Power BANK. If the Green LED doesn't turn on use
BOOST. Refer to the BOOST OPERATION section.
5. Try starting the vehicle (turn on the ignition switch). Most vehicles
will immediately start. Stop if the vehicle does not start after
5 seconds of engine cranking. The jumpstart feature is designed
for short term operation only, and more than 5 seconds may cause
damage to the unit. Allow the jump starter to cool down for at least 3
minutes after each jumpstarting.
6. Disconnect the cable from the Power Bank immediately after
engine starts, and then remove from battery terminals.
TECH-5000P USER'S MANUAL PAGE 11