Haswill STC-200 Quick Start Manual page 2

3. Function Menu
Code Function
F0
Temperature Hysteresis / Difference
F1 Protection Delay Time for the Compressor
F2 Lower Limit for SP Setting
F3 Upper Limit for SP Setting
F4
Refrigeration or Heating or Alarm Mode
F5
Calibration = Real. - Measured.
3.1. Set the "SP" value
1) Press the
https://www.thermo-hygro.com
2) Press the
F3 limited
3) It will back to normal status from the setting interface
in the 30s if without operation.
3.2. Set the "Hysteresis" Value?
1) Hold the
you will see the code F0.
2) Next, press the
value and press the direction key to change it.
3) At last, press the
key, shows the exists SP value;
or keys to change SP, which F2 and
;
+ keys simultaneously for 4s, and
key again to see the current
key to save the new data and
2 / 3