Advertisement
Quick Links
STC-200 Thermostat
Quick Start Guide
(Version 21.08.02GEN)
STC-200+ thermostat with just one relay to control the
power supply status of the wired heater or cooler or
output alarm.
1. Wiring Diagram
https://www.thermo-hygro.com
2. Set the Aimed Temp Range
The aimed temperature range was defined from "SP" to
"SP + F0"; hence you need to set both the "SP" and the
"F0" value.
1 / 3
Advertisement
Related Manuals for Haswill STC-200
Summary of Contents for Haswill STC-200
- Page 1 STC-200 Thermostat Quick Start Guide (Version 21.08.02GEN) STC-200+ thermostat with just one relay to control the power supply status of the wired heater or cooler or output alarm. 1. Wiring Diagram https://www.thermo-hygro.com 2. Set the Aimed Temp Range The aimed temperature range was defined from “SP” to “SP + F0”;...
- Page 2 3. Function Menu Code Function Temperature Hysteresis / Difference Protection Delay Time for the Compressor Lower Limit for SP Setting Upper Limit for SP Setting Refrigeration or Heating or Alarm Mode Calibration = Real. - Measured. 3.1. Set the “SP” value 1) Press the key, shows the exists SP value;...
- Page 3 30s if without operation. This is not a step-by-step user manual; https://www.thermo-hygro.com It just shows the key points. The new user should read the Full-Content Version User Manual Haswill Electronics STC-200+ Thermostat Copyright Haswill-Haswell All Rights Reserved 3 / 3...