Table of Contents
Advertisement
en Installation instructions
Recommended settings
Cakes in tins
Meal
Sponge cake
1
Place the glass cookware side-by-side in the centre of the wire rack. Use heat-resistant glass cookware only. Never
set hot glass cookware down on a cold or wet surface after taking it out of the oven. This may cause the glass cook-
ware to crack.
2
Preheat the appliance for 15 minutes. Never use the rapid heating function for preheating.
Toast
Dish
Toasting bread, 15 slices
1
Place the bread for toasting in the centre of the wire rack.
2
Preheat the appliance for 4 minutes. Never use the rapid heating function for preheating.
22 Installation instructions
The installation instructions contain instructions for
the gas connection and for the gas conversion's as-
sembly .
Note: For after-sales service only.
22.1 General information
Your appliance must only be converted from
one gas type to another by authorised per-
sonnel who have received appropriate train-
ing. The procedure must always be carried
out in accordance with the instructions in
this manual.
Incorrect connection and incorrect settings
may damage the appliance. The appliance
manufacturer shall accept no liability for in-
correct connections or incorrect settings.
¡ Wear protective gloves so that you do not
cut yourself. Accessible parts may have
sharp edges.
¡ Do not place the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.
¡ Never install the appliance in boats or in
vehicles.
38
Accessory/cookware Shelf posi-
1
Accessory/cookware Shelf posi-
1
Wire rack
Type of
tion
heating
3
Power
tion
level
2
5
¡ Always closely observe the symbols on the
rating plate. If there is no symbol that is rel-
evant to your country, comply with the tech-
nical guidelines in force in your country
when configuring the appliance settings.
¡ Find out which gas type and which gas
pressure your local gas supply network
uses before installing the appliance. Before
using the appliance, ensure that all settings
have been set correctly.
¡ Always comply with local and national
guidelines and regulations.
¡ The settings for configuring your appliance
can be found on the rating plate on the
rear of the appliance. The gas type set at
the factory is marked with an asterisk (*).
¡ After converting the appliance from one
gas type to another, the new gas type must
be labelled on the rating plate.
– Use the gas conversion label to do this.
– (*) is used to indicate the gas type on the label.
– Stick the label on which the gas conversion is
marked with a star (*) in the designated location
on the rating plate.
¡ The changes made to the appliance and
the type of connection are essential to en-
abling the appliance to work safely and in
accordance with the relevant regulations.
¡ Switch off the power supply and gas supply
before carrying out any work.
Temperature
Cooking
in °C
time,
minutes
2
160
35-40
Type of heat-
Cooking
ing
time, mins
1.5-2.5
Advertisement
Table of Contents
