Table of Contents
Advertisement
Index Sea rch
Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.
N O TE:
Before starting, make sure the
recorder is in the Stop mode.
ACTIVATE IN DEX SEARCH
1
Press PU SH JO G
" £ 1" is displayed on screen and search begins in
the corresponding direction.
● To access index codes 2 through 9, press
or
repeatedly until the correct index number is
displayed.
Ex.: To locate the beginning of B from the current
position, press PU SH JO G
To locate the beginning of D from the current
position, press PU SH JO G
● When the specified index code is located, playback
begins automatically.
Counter M emory
Returns to the counter reading of " 0:00:00" to conveniently find
a specific place on the tape automatically.
SET CO UN TER MEMO RY
1
Press C. (CO U N TER) RESET during playback at a point
you wish to locate later. The counter reads " 0:00:00" .
Then press C.M EM O RY , and " M" appears in front of the
counter digits.
ACTIVATE CO UN TER
MEMO RY
2
When you wish to return to the designated point, press
STO P and then REW or FF .
● The tape rewinds or fast-forwards and stops at about
0:00:00 automatically.
● To cancel Counter Memory, press
Downloaded from:
https://www.usersmanualguide.com/
or
( ™ or £ ). " ™ 1" or
PU SH JO G
twice.
once.
Current position
A
B
C
D
E
F
–2
–1
1
2
3
Index number
C.M EM O RY again.
Repea t Pla yba ck
Your video recorder can automatically play back the whole tape
£ 2
20 times repeatedly.
ST ART PLAYBACK
1
Press PLAY .
ACTIVATE REPEAT
PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
● The Play indicator ( $ ) on the display panel blinks
slowly.
● The tape plays 20 times automatically, and then
stops.
STO P PLAYBACK
3
Press STO P at any time to stop playback.
N O TE:
Pressing PLAY , REW , FF or PAU SE also stops Repeat Playback.
N TSC Pla yba ck
Your video recorder is equipped with NTSC circuitry that can
play back NTSC tapes.
LO AD A CASSETTE
1
Insert a cassette recorded in NTSC.
ST ART PLAYBACK
2
Press PLAY .
● "NTSC" appears on the screen for about 5 seconds.
● Some TVs shrink the picture vertically and place
black bars at the top and bottom of the screen. This is
not a malfunction on the part of either the video
recorder or the TV.
● The picture may roll up and down. This can be
corrected using the V-HOLD control found on some
TVs. (This cannot be corrected if the TV does not
have a V-HOLD control.)
● The counter and tape remaining time readings will be
incorrect.
● During search, still, or frame-by-frame playback, the
picture will be distorted, and there may be a loss of
colour.
● Depending on the type of TV, the top and bottom
portions of superimposed displays may be cut off
during NTSC playback.
15
Advertisement
Table of Contents
