Kenmore KW3030 Use & Care Manual page 14

9. Once you have completed vacuuming,
flip the on/off switch to the 'O' OFF
position and unplug the power cord from
the outlet.
O = OFF I = ON
WARNING
Be sure to read, understand, and apply
information entitled 'important safety
instructions'. Do not vacuum in areas
with flammable gases, vapors, or
explosive dusts in the air. Flammable
gases or vapors include but are not
limited to: lighter fluid, solvent type
cleaners, oil-based paints, gasoline,
alcohol, or aerosol sprays. Explosive
dusts include but are not limited to:
coal, magnesium, grain, or gun powder.
To reduce the risk of health hazards
from vapors or dust, do not vacuum
toxic materials.
WARNING
Do not plug the power cord into
electrical supply. Make sure the plug
is disconnected before changing the
filters.
1. Verify that the power cord is
disconnected from the outlet. Make sure
that the collection tank is clean and free
of dust and dirt.
DRY VACUUMING OPERATION
LIQUID VACUUMING OPERATION
CAUTION
DO NOT USE THE REUSABLE CLOTH
FILTER FOR LIQUID VACUUMING.
CAUTION
DO NOT USE DUST BAG FOR LIQUID
VACUUMING.
2. Remove the reusable cloth filter, then
carefully install the foam wet filter over
the filter cage and place the powerhead
back on the collection tank. For foam
wet filter installation instructions, see
page 19.
CAUTION
DO NOT USE THE REUSABLE CLOTH
FILTER FOR LIQUID VACUUMING.
CAUTION
DO NOT USE DUST BAG FOR LIQUID
VACUUMING.
- 14 -