Kenmore KW3030 Use & Care Manual page 15

3. Choose the desired accessory and insert
onto the end of the hose or extension
wand.
4. Verify that the on/off switch is in the 'O'
OFF position before plugging the power
cord into the power outlet. Plug the
power cord into the outlet.
5. Turn the motor on by flipping the switch
to the 'I' ON position.
LIQUID VACUUMING OPERATION
6. Once you have completed vacuuming,
flip the switch to the 'O' OFF position
and unplug the power cord from the
outlet.
7. After use, empty the collection tank,
clean and dry the inside and outside of
the collection tank.
IMPORTANT! When vacuuming large
quantities of liquids, do not immerse the
nozzle completely in the liquid; leave a
gap at the tip of the nozzle opening to
allow air inflow. The machine is fitted
with a float valve that stops the suction
action when the collection tank reaches
its maximum capacity. You will notice
an increase in motor speed. When this
happens, turn off the machine, disconnect
from electrical supply, and drain the liquid
into a suitable receptacle or drain. To
continue vacuuming, refit the powerhead to
the collection tank. After wet vacuuming,
turn the machine off and remove plug
from electrical supply. Empty the collection
tank, clean, and dry the inside and outside
before storage.
IMPORTANT! The foam wet filter must
be removed after wet vacuuming and
the reusable cloth filter must be installed
before dry vacuuming again.
- 15 -