Moving The Appliance - Sub-Zero International PRO Series Manual

International Pro-Series
International Pro-Series

MOVING THE APPLIANCE

After uncrating the unit, do not discard the kickplate that
is taped to the side of the refrigerator. Do not discard
the Anti-Tip Kit or hardware, you will need them to block
the installation.
Carefully move the unit from the crate base onto an
appliance dolly. Tip to one side removing styrene pads
under unit. Tip back onto appliance dolly. Retract lev-
eling legs to their uppermost position for easy move-
ment of the unit while installing. Remember this unit is
very heavy (408kg) and enough manpower should be
used when attempting to move this equipment.
Protect the Flooring
Make sure the floor under the refrigerator is level with
the surrounding finished floor. Pushing the unit with
front leveling legs down will cause damage to the floor.
Make sure the leveling legs are in the uppermost posi-
tion prior to moving the product. Protect a finished floor
with masonite, plywood, 3 mm (minimum) pressed fiber-
board or some other suitable material before moving
the refrigerator across it.
Protect any finished flooring before moving the unit in
place. This Sub-Zero product is equipped with rollers,
so it can be easily moved into place. If for any reason
the unit has been laid on its back side, you must allow
the unit to stand upright for a minimum of 24 hours
before connecting power.
Removing the Grille
In order to prevent damage to the grille, the top grille
assembly should be removed prior to moving the unit.
To remove the grille assembly, pull out on the bottom
edge of the grille and tilt the grille frame forward
Figure 2-4). Disconnect the low-voltage cable which
connects the User Displays on the grille to the
Technician Display Module, and cut the two white cable
ties which attach the network cable to the right grille
support. These cables ties should be replaced once
the unit is properly installed with the extra cable ties
provided. Remove the three bolts from base of the
grille. Remove the screw from the upper grille area and
remove the grille assembly.
(ICB648PRO)
(ICB648PRO)
Product is very heavy (408kg) keep door(s) and draw-
er(s) closed while moving unit and use enough man-
power to safely move unit.
When using appliance dolly, make sure the strapping is
underneath the door handles and either underneath or
over the top of drawer handles. Use enclosed corner
protectors to avoid damage to stainless steel. Do not
cut corner protectors when unpacking the product.
(See
2-5
Installation Information
UPPER GRILLE
SCREW
LOW-VOLTAGE
DISPLAY CABLE
LOWER 7/16"(11) GRILLE BOLTS
Figure 2-4. Grille Removal
#7004858 - Revision A - April, 2007