Table of Contents
Advertisement
• remove all food from the compartment and clean the inside
and accessories;
• clean the cabinet, going over all the stainless steel surfaces
vigorously with a rag moistened with paraffin oil to create a
protective film;
I
TROUBLESHOOTING
I.1
Introduction
Certain faults may occur during normal use of the appliance. In
some cases, faults can be eliminated easily and quickly by
following the indication below.
The display, if present, always shows a warning message or
alarm describing the occurring fault.
If the fault persists, contact the Customer Care Service:
1. Disconnect the appliance from the main power supply;
2. Switch off the safety circuit breaker ahead of the
appliance;
3. Remember to specify:
I.2
Troubleshooting
TYPE OF
ANOMALY
ANOMALY
E0
ALARM
rE
E1
ALARM
E2
ALARM
CLN
ALARM
Ser
ALARM
CN
ALARM
14
• leave the door or drawers, if present, open so that air can
• periodically air the premises.
DESCRIPTION
POSSIBLE CAUSES
• Connector unplugged;
Compartment
• Probe and/or Probe wire
sensor fault
damaged.
• Connector unplugged;
Evaporator sensor
• Probe and/or Probe wire
fault
damaged.
Condenser sensor
fault
Probe and/or Probe wire
• Position of condenser
probe is not correct;
• Fan condenser not
working;
Condenser cleaning
• The condenser is dirt or
alarm
the grid has tapped holes;
• The unit cannot dissipate
heat because of its
positioning.
• Position of condenser
probe is not correct;
• Fan condenser not
working;
Condenser high
• The condenser is dirt or
temperature
the grid has tapped holes;
• The unit cannot dissipate
heat because of its
positioning.
• Internal error
Communication
disconnected;
error between con-
• Electronic boards;
troller and LED lamp
• Electronic board failure.
circulate inside, preventing the formation of unpleasant
odours;
• the type of fault
• the appliance PNC (product number code)
• the Ser. No. (appliance serial number).
IMPORTANT
The appliance PNC and serial number are essential
for identifying the type of appliance and date of
manufacture.
The dataplate giving the product and technical data
is located inside the appliance. The plate giving the
appliance PNC code and serial number is located in
the unit compartment.
•
Connector unplugged;
•
damaged.
• Use a vacuum cleaner and
• If the alarm persists Call
• Use a vacuum cleaner and
• If the alarm persists Call
• The appliance will continue
• Try to switch the unit OFF/
• If the problem persists, Call
ACTIONS
CALL SERVICE
CALL SERVICE
CALL SERVICE
remove any dust/dirt from
the condenser inlet-air grid.
Service.
remove any dust/dirt from
the condenser inlet-air grid.
Service.
working with reduced func-
tionality (door opening
cannot be detected);
On;
Service.
Advertisement
Table of Contents
