Using The Fixed Disk Setup Option - Epson Endeavor Pro User Manual

System Setup options (continued)
* Default setting
(1) If you installed a video adapter card, make sure you disable the
on-board SVGA controller by setting jumper JP2 to position 2-3; see
"Changing the Jumper Settings" in Chapter 4 for instructions.
(2) If the System memory and Extended memory values are not correct,
check that the SlMMs are installed correctly, as described in "Installing
Memory Modules (SIMMs)" in Chapter 4.

Using the Fixed Disk Setup Option

The Fixed Disk Setup
disk drives connected to the primary and secondary IDE
interfaces in your system. When you select this option, you see
the Fixed Disk Setup screen.
Note
These options do not configure other IDE devices, such as
CD-ROM drives, connected to the secondary IDE interface.
Fixed Disk Setup screen options
Make sure the
DOS (the default setting). Set this option to
using UNIP or an operating system other than MS-DOS@ or
Windows.
Large Disk Access Mode
Running SETUP and Installing Drivers
option defines the types of hard
Other
option is set to
if you are
2 - 5