Table of Contents
Advertisement
FOREWORD
Thank you for purchasing the RMK-4
The RMK-4 allows you to connect the additional CONTROL
HEAD to the IC-F9511HT to enable dual-head operation.
Depending on the length of separation you need, use either
the optional OPC-607, OPC-608, OPC-609 or OPC-726
with the RMK-4.
ARATION CABLE
EXPLICIT DEFINITIONS
WORD
Personal injury, fire hazard or electric
RWARNING
shock may occur.
Equipment damage may occur.
CAUTION
If disregarded, inconvenience only. No risk
NOTE
of personal injury, fire or electric shock.
Please refer to the instruction manual of the transceiver
for details of the basic operation.
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incor-
porated (Japan) in Japan, the United States, the United Kingdom, Germany,
France, Spain, Russia and/or other countries.
All other products or brands are registered trademarks or trademarks of their
respective holders.
i
.
SEPARATION KIT
-
SEP
DEFINITION
PRECAUTIONS
RWARNING! NEVER
(with the RMK-4) and CONTROL HEADs where normal operation of
the vehicle may be hindered or where they could cause bodily injury.
CAUTION!
To avoid damage to the transceiver, turn the
power OFF and disconnect the DC power cable from the trans-
ceiver's main unit before disassemble the transceiver.
DO NOT
use or place the transceiver's main unit (with the
RMK-4) and CONTROL HEADs in areas with temperatures
below –30°C (–22°F) or above +60°C (+140°F).
DO NOT
use chemical agents such as benzine or alcohol
when cleaning, as they can damage the RMK-4 and CONTROL
HEAD's surfaces.
USE
the specified microphone only. Other microphones have
different pin assignments and may damage CONTROL HEAD or
the transceiver's main unit.
KEEP
the transceiver's main unit (with the RMK-4) and CON-
TROL HEADs away from heavy rain, and never immerse them
in the water.
The transceiver's main unit (with the RMK-4) and CONTROL
HEADs meet IP54 requirements for dust-protection and splash
resistance when the optional microphone*, the front/rear plate(s)
and the speaker jack cover of CONTROL HEAD are attached.
However, if these items are dropped, dust-protection and splash
resistance cannot be guaranteed because of possible damage to
the cases or the waterproof seals.
* The microphone is not dust-protection and splash resistant.
place the transceiver's main unit
Advertisement
Table of Contents
