Table of Contents
Advertisement
22 October 2019
16) Tighten all fittings ensuring a
positive connection.
17) Secure hoses with provided tie
straps and insulated clamp.
18) Route wiring harness from
transmission cooler along frame
into engine compartment.
19) Under vehicle insert two pin
connector on harness into fan
motor connector, then connect
harness to temperature switch with
blade connectors once appropriate
wire is cut and trimmed to length.
20) Mount relay in a suitable location in
the engine compartment using
supplied self-taping screw.
21) Next trim the wires to length and
crimp the ring terminals to the
BLACK and RED wires.
Connect positive terminal only.
(Driver side battery)
22) Lastly open the fuse box and locate
the 12V ignition switched fuse by
using a digital volt meter or 12V
test light. Remove fuse and install
fuse tapper onto fused side and
reinstall. (5 amp fuse is minimum
requirement)
U.S. Shipping Address: 1124 Fir Avenue, Blaine, WA 98230
1030606 Transmission Cooler Instruction Manual (I-00213)
OEM COOLER
Using the Compression Fitting
TRANSMISSION
FAN MOTOR
CONNECTION
BD Engine Brake Inc.
Plant Address: 33541 MacLure Rd. Abbotsford, BC, Canada V2S 7W2
Phone: 604-853-6096 | Fax: 604-853-8749 | Internet: www.bddiesel.com
DODGE 518, 47RH, 47RE, 48RE
OUTLET
INLET
LINE
U.S. Mailing Address: P.O. Box 231, Sumas, WA 98295
INLET
NOTE
SLEEVE
ORIENTATION
WHEN INSERTING INTO FITTING
8
Transmission
Cooler
HOSE
Advertisement
Table of Contents
