Table of Contents
Advertisement
22 October 2019
Optional Temperature Sensors
180 ON / 160 OFF
1300620 (black wire leads)
Before you install your BD Transmission Cooler
If using the BD transmission cooler in extreme cold temperatures
a bypass valve is recommended.
Cooler fan is rated for 66% duty cycle Maximum. Exceeding the
duty cycle may result in voiding the warranty.
The temperature sensor is designed to turn on at 180°F / off at
160°F.
Installation
1) Block wheels of vehicle for safety and disconnect negative battery terminals (record radio settings
before disconnecting the batteries).
2) Using a hoist lift vehicle to access
transmission area.
3) Locate suitable location to mount
transmission cooler. Choose a
location where there will be
adequate airflow through the cooler.
If the cooler is mounted against a
surface ensure there is at least 1" of
clearance behind the cooler and
that it is away from heat sources,
rotating parts and debris.
4) Assemble L brackets and 5/16"
hardware to mount the transmission
cooler to the frame rail. Trim bracket
pieces where necessary, deburr
sharp edges and paint areas that
are exposed to prevent corrosion.
U.S. Shipping Address: 1124 Fir Avenue, Blaine, WA 98230
1030606 Transmission Cooler Instruction Manual (I-00213)
(comes in kit)
(fig.2)
Plant Address: 33541 MacLure Rd. Abbotsford, BC, Canada V2S 7W2
Phone: 604-853-6096 | Fax: 604-853-8749 | Internet: www.bddiesel.com
200 ON / 185 OFF
(available separately)
1300621 (orange wire leads)
Note: This is a universal cooler that can be mounted in a
variety of locations
1
1300602– L Bracket
1604104 – 5/16" X 1" Bolt
2
1110031 – 5/16" Flat washer
3
1110032 – 5/16" Lock washer
4
1130227 – 5/16" Nyloc nut
5
BD Engine Brake Inc.
U.S. Mailing Address: P.O. Box 231, Sumas, WA 98295
5
Advertisement
Table of Contents
