Table of Contents
Advertisement
22 October 2019
10) Thread JIC temp switch adaptor
onto cooler large sweep connector.
11) Locate transmission inlet line
Mark and cut transmission line
where the line is completely
straight with no bends or damage
for about 3" to mount compression
fittings. NOTE: Tube attached to
transmission can be rotated for
easy routing of hose.
12) Cut transmission line with pipe
cutter. Deburr inner and outer pipe
edges on both sides.
13) Insert barb-compression fitting onto
cut cooler line ensuring fitting
bottoms out and tighten hand tight.
Then using two wrenches tighten to
crush ferrule 1 1/4 turns.
14) Measure/cut supplied 1/2" hose to
length ensuring hose reaches
cooler from transmission without
being stressed.
15) Install hoses onto barbed fittings
using provided gear clamps and
tighten. (Refer to general hose
routing diagram for general layout.)
U.S. Shipping Address: 1124 Fir Avenue, Blaine, WA 98230
1030606 Transmission Cooler Instruction Manual (I-00213)
FRONT OF
VEHICLE
.
Line Position Reference
(fig 1.1)
FORD E40, 4R100, 5R110
DODGE 68RFE
General hose routing (Dodge 518, 47RH, 47RE, 48RE)
BD Engine Brake Inc.
Plant Address: 33541 MacLure Rd. Abbotsford, BC, Canada V2S 7W2
Phone: 604-853-6096 | Fax: 604-853-8749 | Internet: www.bddiesel.com
(fig 1.1)
FORD 6R140
OUTLET
INLET
OUTLET
INLET
U.S. Mailing Address: P.O. Box 231, Sumas, WA 98295
Pipe Sealant
ALLISON
INLET
OUTLET
DODGE 518, 47RH, 47RE, 48RE
OUTLET
INLET
7
Advertisement
Table of Contents
