Gigabyte R133-C11-AAB1 User Manual page 84

MBA Device Configuration
Menu
iSCSI Boot Configuration
Menu
Blink LEDs
Chip Type
PCI Device ID
Bus:Device:Function
Link Status
Permanent MAC Address
Restore Defaults
Press [Enter] to configure advanced items.
Legacy Boot Protocol
Š
– Select ono-UEFI Boot protocol.
– PXE, ISCSI, NONE. Default setting is NONE.
BOOT Strap Type
Š
– Select boot strap type.
– Options available: Auto Detect, BBS, Int 18h, Int 19h. Default setting
is Auto Detect.
Hide Setup Prompt
Š
– Configure whether Setup Prompt is displayed during ROM
initialization.
– Default setting is Disabled.
Setup Key Stroke
Š
– Configureskey strokes to invoke configuration menu.
– Default setting is Ctrl-S.
Banner Message Timeout
Š
– Select timeout value.
Link Speed
Š
– Configures the link speed.
– Options available: AutoNeg, 10Mbps Half, 10Mbps Full, 100Mbps
Half, 100Mbps Full. Default setting is AutoNeg.
Pre-boot Wake On LAN
Š
– Configures Pre-boot Wake On LAN (WOL).
– Options available: Enabled, Disabled.. Default setting is Disabled.
VLAN Mode
Š
– Configures virtual LAN mode.
– Options available: Enabled, Disabled.. Default setting is Disabled.
VLAN ID
Š
– Configures virtual LAN ID.
– This item is configurable when VLAN mode is set to Enabled.
Press [Enter] to configure advanced items.
Identifies the physical network port by blinking the associated LED.
Press the numeric keys to adjust desired values.
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller.
Displays the link status.
Displays the MAC address of the Ethernet controller.
Resets the adapter to factory defaults.
BIOS Setup
- 84 -