Advertisement
Room Wizard
Operation
Your Pet Stop RoomWizard can be set up in your home either as wireless or a wired system, depending on the
needs of you and your pet.
Pet Stop RoomWizard – Wireless Operation
Place the RoomWizard unit in the location you want your pet to avoid. For example, if you do not want your pet
to jump on the sofa, place the unit under the sofa. The RoomWizard can also be permanently mounted on a
wall using the key hole slot on the bottom of the transmitter case.
Under normal operation, the RoomWizard will display the signal field strength number (such as "10") and will
make no sounds. This indicates the RoomWizard is operating normally. You can make adjustments to the
signal field range to achieve the correction zone you desire. Pressing the upper button ("+") will increase the
signal field to a maximum of 32. Pressing the lower button ("-") will decrease the signal field to a minimum of 1.
To turn on the RoomWizard unit:
1.
Plug the AC adapter into an AC electrical outlet.
2.
Plug the other end of the AC adapter into the LEFT connector on the RoomWizard marked
"Power" as shown in photo below.
3.
The Range display should be lit to indicate the RoomWizard is on. If the range display is
not lit, press the top Range Adjustment button to turn the unit on.
4.
Adjust the signal field range by pushing the upper button (+) to increase the range and the
lower button (–) to decrease the range.
5.
Test the signal field range by using the receiver collar and listening for the beeps.
Remember: Always remove your pet's Pet Stop receiver collar before
making any adjustments to the signal field range.
Pet Stop | Owner's Guide
11
Advertisement
