Chevrolet B7 2001 Owner's Manual page 153

Then, follow the steps below for the wheels you have.
CAUTION:
Never use oil or grease on studs or nuts. If you
do, the nuts might come loose. Your wheel could
fall off, causing a serious accident.
- -
Hub Piloted Wheels, 8 Hole or 10
The studs and nuts used with these wheels have
-
right hand threads.
1. With intermittent pilot pads, position a pad at
12 o'clock to center the wheel and reduce run
2. Put the tire and rim assembly on the axle hub. Install
the outer rear tire and rim assembly so that its valve
stem is exactly opposite the valve stem on the inner
tire and rim assembly.
3. Put on the wheel nuts.
-
4. Finger tighten the nuts.
4-42
-
Hole
-
out.
5. Oil the surfaces
between the nuts
and washers as
shown. Do not oil
the studs or the
threads of the nut.
6. Tighten the nuts to
400 lb
if an eight
stud or 480 lb
(650 N·m) if a
-
10
using the
following diagrams.
-
8 Hole
-
ft (542 N·m)
-
hole
-
ft
hole stud