Table of Contents
Advertisement
Replacing Modules
Figure 6: Supervisor Module Latch Release Lever
1
Loosen the thumb-screw on the module.
3
Rotate the latch away from the module to disengage from
the chassis.
Step 3
To install the module, follow these steps:
a) Make sure that the lever is in the fully open position.
b) Hold the module with one hand and place your other hand under the module to support its weight.
c) Align the module with the open slot and gently slide the module into the slot until the lever's clamp engages with the
chassis. Then rotate the lever up and toward the chassis until it clicks into the fully closed position .
d) Tighten the module thumb-screws.
2
Press the latch down to release the latch from
the chassis.
4
Pull the module out of the chassis.
Cisco Nexus 9408 NX-OS Mode Switch Hardware Installation Guide
Replacing a Supervisor Module
33
Advertisement
Table of Contents
