Table of Contents
Advertisement
WIRING: INPUTS AND OUTPUTS
Analog Inputs Information
Raw input values for channels 1-4 are found in the registers
as Integer- type data with a range from 0 – 32000.
Analog inputs may be filtered digitally with the Filter Con-
stant found in the Cscape Hardware Configuration for Ana-
log Inputs. Valid filter values are 0-7 and act according to
the following chart:
Data Values
Input Mode:
0-20mA, 4 -20mA
0-10V
Digital Inputs
Digital inputs may be wired in either a Positive Logic or Neg-
ative Logic fashion as shown. The setting in the Cscape
Hardware Configuration for the Digital Inputs must match
the wiring used in order for the correct input states to be
registered. When used as a normal input and not for high
speed functions, the state of the input is reflected in
registers %I1 – %I12.
Data Format, 1 2-bit I NT:
0-32000
0-32000
Jumper Settings for Model 3
Location of I/O jumpers (JP1 & JP3) and wiring connectors
(J1, J2, J3 & J4) with back cover removed.
JP1 Digital DC Inputs
JP3 Analog In
NOTE: The Cscape Module Configuration must match the
selected I/O (JP) jumper settings.
NOTE: When using JP3 (A1-A2), each channel can be inde-
pendently configured.
Back Panel Torque Ratings
XLE/XLT: 3.0 - 4.0 in-lbs (0.34 - 0.45 N-m)
XL4/XL4 Prime: 3.0 - 4.0 in-lbs (0.34 - 0.45 N-m).
EXL6/XL6 Prime: 3.0 - 4.0 in-lbs (0.34 - 0.45 N-m)
EXLW/ XLW Prime: 3.0 - 3.5 in-lbs (0.34 - 0.40 N-m)
XL7/XL7 Prime: 3 .0 - 3.5 in-lbs (0.34 - 0.40 N-m)
EXL10/XL10 Prime: 3 .0 - 3.5 in-lbs (0.34 - 0.40 N-m)
Page 5
Wiring: Model 3
Advertisement
Table of Contents
