Table of Contents
Advertisement
ECS Device Installation
2.
Insert microphone cord through hole at the bottom of the dead front panel.
3.
Attach strain relief clip to microphone cord. The strain relief clip should have about 2.75" of microphone cord through it.
4.
Push the strain relief into the hole in the dead front panel.
5.
Connect microphone to connector on ECS-EMG.
4.4 Installing the ECS-50W
This section provides information on how to install the ECS-50W for use with the ECS Series products. ECS-50W is also available in a black
cabinet as P/N ECS-50WB.
22
microphone
cord
Figure 4.17 Inserting Microphone Cord Through Dead Front Panel Hole
1.
Figure 4.18 Installing Strain Relief Clip
back of dead front panel
back of ECS-EMG
2.
ECS Series Manual — P/N 151455:H 2/15/2022
Installing the ECS-50W
2.75"
Advertisement
Table of Contents
