2: Installing The Ecs-Vcm; 3: Connecting The Ecs-Vcm To The Sbus - Honeywell Farenhyt ECS Series Manual

Installing the ECS-VCM
4.2.2 Installing the ECS-VCM
1. Open the cabinet door and the dead front panel.
2. Remove AC power and disconnect the backup batteries from the main control panel.
3. Align the ECS-VCM over the mounting studs in the middle section of the dead front panel and secure with the six supplied nuts with
lockwashers. Refer to the figure below for mounting locations.
Back view of IFP-100ECS/IFP-1000ECS Dead Front Panel
4.2.3 Connecting the ECS-VCM to the SBUS
Refer to Figure 4.4 below to properly connect the ECS-VCM to the FACPs SBUS.
See Section 4.11 for instruction on how to set SBUS addressing.
ECS Series Manual — P/N 151455:H 2/15/2022
+
ECS-VCM
+
+
+
+
ECS-SW24
Figure 4.3 ECS-VCM Mounting Locations
ECS-VCM
FACP
Figure 4.4 ECS-VCM SBUS Connections
ECS-SW24
Back view of IFP-2000ECS Dead Front Panel
+
+
+
ECS Device Installation
ECS-VCM
+
+
+
+
+
ECS-SW24
supervised,
power-limited
Class B
15