Distech Controls ECLYPSE Quick Start Manual

Default User Credentials

Use the following credentials to access the ECLYPSE Web Interface:
Username: admin
Password: admin
This password is only valid for a first-time connection and you will be prompted to change it after your first
login. Please ensure note down the changed password.
Locating the Default Network Configurations on the ECY-STAT (Home > About)

Default IP Configurations

The default WiFi IP address for the ECY-STAT Hotspot is 192.168.0.1.
The ECY-STAT is also automatically set in DHCP mode and requires a connection to a router acting as DHCP
server to communicate to a network. This setting may be changed through the ECLYPSE Web Interface.

Resetting WiFi Configurations

The Reset Wi-Fi Configuration option will re-activate the Hotspot on the ECY-STAT. It is used when an
ECY-STAT in Wi-Fi client mode is unable to connect to its Wi-Fi network, because of a wrong password, for
instance. To perform this, select Main Menu > Settings > Advanced Settings (you may have to enter your login
credentials again) > Reset Wi-Fi Configuration.
Follow these simple steps to get started with the ECLYPSE Connected Thermostat:
There are two networking methods to connect to an ECY-STAT for the first time:
•
Wi-Fi.
•
Wired (Ethernet connection to a router that will act as a DHCP server).
Once you have connected the thermostat(s) to a network, configure the thermostat.
Distech Controls, Inc. – 4205 place de Java, Brossard, Quebec, J4Y 0CA, Canada / Tel: +1 450 444 9898 / Fax: +1 450 444 0770
ECLYPSE Connected Thermostat (ECY-STAT)
Quick Start Guide
General Information

Connection Procedures