Connect The Power Cord And Other Cables To The Projector - Epson BrightLink 475Wi Installation Manual

3. Tighten the M4 x 12 mm hexagon socket head cap bolts (x2) (
Slide plate
Projector
interface side
Spring washer
M4 x 12 mm hexagon socket head cap bolts
Warning
When installing or adjusting the wall mount, do not use adhesives to prevent the screws from
loosening and do not use lubricants or oils on the projector slide plate. This may cause the
case to crack and the projector to fall, resulting in personal injury or property damage.
I

Connect the power cord and other cables to the projector

Connect any necessary cables such as the power cord, computer cable, HDMI cable, and USB cable to
the projector.
If you are planning to run the cables inside the wall, make sure you follow all local electrical codes. If
you are running the cables outside the wall, use a cable management system to keep the cables from
obstructing the image. An optional cable management system is available from Epson (part #
ELPCK01).
Washer
Alignment marks
Computer cable
33
).
Bolt positions
USB cable
Power cord