Agilent Technologies 33120A Installation Instructions Manual page 4

6 Connect the coaxial cable to Agilent 33120A circuit board.
First, slide the black ferrite bead to the end of the coaxial cable as shown.
Then, connect the coaxial cable to connector J401 on the 33120A circuit
board. Be sure to position the cable away from the heatsinks on the
circuit board.
7 Connect the ribbon cable to the Agilent 33120A circuit board.
Connect the loose end of the grey ribbon cable to connector J102 on the
33120A circuit board. Press down firmly on the ribbon cable connector
and secure the cable in place with the locking clips.
J401
J102
Ribbon
Cable
4
Ferrite Bead
Snap the Locking Clips
over the top of the connector
to secure the Ribbon Cable.