Safety - Husqvarna 321SP Operator's Manual

Symbols on the product
Read this manual before operating
Wear protective headgear, protective
goggles, ear muffs and protective mask
Wear rubber boots
Wear protective clothing
Wear rubber gloves
Electric shock
Hot surface
High pressure injection
Keep safe distance
The port to refuel the MIX GASO-LINE
The direction to close the choke
The direction to open the chok
Safety definitions
The definitions below give the level of severity for
each signal word.
WARNING: Injury to persons.
CAUTION: Damage to the product.
Note: This information makes the product easier to
use.
General safety instructions
WARNING: Read the warning instructions
that follow before you use the product.
•Use the product correctly. Injury or death is a
possible result of incorrect use. Only use the
product for the tasks found in this manual. Do not
use the product for other tasks.
Primer
Low speed
High speed
Note: Other symbols/decals on the product refer to
certification requirements for other commercial areas.
Product liability
As referred to in the product liability laws, we are
not liable for damages that our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not from
the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
• the product is no repaired at an approved service
center or by an approved authority

SAFETY

• Read, understand and follow the instructions and
the symbols in this manual. If the operator does
not follow the instructions and the symbols, injury,
damage or death is a possible result.
• Do not discard this manual. Use the instructions to
assemble, to install attachments and accessories,
to operate and to maintain. Only use approved
attachments and accessories.
• It is not possible to give warning on every situation
that can occur during operation and maintenance
of the product. Always be careful and use your
common sense.
• Make sure that parts are not damaged before you
use the product. Follow the maintenance
schedule. Only do the maintenance work that
instructed in this manual. An approved service
center must do all other maintenance work.
• Do not operate the product or do maintenance on
the product if you are not sure of the situation.
Turn to the approved dealer, service agent or
service center for information.
3