Sony SU-WL500 Installation Manual page 5

A: landscape, -20° leaning
Step 1:
Checking the parts
required for the
installation
Follow Step 1 in the SU-WL500 instruction manual to
check the parts.
Step 2:
Deciding on the
installation location
Follow Step 2 in the SU-WL500 instruction manual to
decide on the installation location. Refer to page 19
of this manual for the display installation dimension
table.
Step 3:
Installing the Base
Bracket on the wall
Follow Step 3 in the SU-WL500 instruction manual to
install the Base Bracket.
Step 4:
Preparing for the
installation of the
display
1
Remove the stands if they are
installed to the display (FW-
49BZ35F only).
Be sure to lay down the display on a soft cloth
to protect the display. The installation of the
Mounting Hook is also done with the display
laid down.
FW-49BZ35F
When using an electric screwdriver, set the torque
setting to approximately 2 N·m {20 kgf·cm}.
Do not lift the Mounting Hook before the screws
(two screws each for left/right) are secured. This
may distort the Mounting Hook or the display
cabinet.
5
(GB)