Advertisement
Assembly
Assembling the Handle to the Pellet Oven Door
Fig 1
Assembling the Handle to the Pellet Oven Tray
Fig 2
Fig 3
8
1. Affix two Handle Screws and
Lock Nuts using a Phillips head
screwdriver and pair of pliers.
Place the Handle on the door as
shown in Fig 1.
2. While holding the Lock Nuts
with a pair of pliers, turn the
screw
clockwise
until
fully
tightened.
1. Affix two Handle Screws and
Lock Nuts using a Phillips head
screwdriver and pair of pliers.
Place the Handle on the Pellet
Tray as shown in Fig 2.
2. While holding the Lock Nuts
with a pair of pliers, turn the
screws clockwise until fully
tightened.
3. Place the Pellet Grate into the
Pellet Tray with the Pellet Grate
angled down from the Handle
side of the Pellet Tray as shown
in Fig 3.
Assembly (Cont.)
Assembling the Chimney
1. The Upper Chimney has a threaded
receptacle where the Wing Nut is
placed. Slide the Upper Chimney
over the Lower Chimney until it
stops.
2. Rotate the Wing Nut into the
Upper Chimney receptacle until it
is hand tight. Slide the tab of the
Flame Deflector into the slot of
the Upper Chimney. See Fig 4.
3. Place the Assembled Chimney into
the Chimney Receptacle in the
Top Housing of the Pellet Oven.
Ensure the Flame Deflector is
facing away from the front of the
oven. See Fig 5.
Assembling the Pizza Peel
1. The included Pizza Peel comes assembled with the Handle folded.
Before using the Pizza Peel, loosen the Pizza Peel Nut by turning
counterclockwise. There is no need to fully remove the Nut. Rotate
the Handle until it is fully extended straight out. See Fig 6.
2. Rotate the Pizza Peel Nut clockwise to hand tighten. Ensure the
Handle is locked in place by trying to turn it left or right.
Raised Side of Peel Facing Up
9
Fig 4
Fig 5
Fig 6
Advertisement
