Cleaning Nozzle, Injector Ring And Ice Chute; Cleaning Ice Bin - Coca-Cola freestyle 7000 User Manual

COCA-COLA FREESTYLE 7000 | MAINTENANCE
®

Cleaning nozzle, injector ring and ice chute

Cleaning nozzle and injector ring
Using a clean Scrub ring area including holes with
1 4
cloth, twist pointed end of nozzle brush dipped
the nozzle in sanitizer .
counter
clockwise and
Scrub inner
pull down to
injector rings with
remove .
wire-handled brush
dipped in sanitizer .
2 Scrub nozzle with blunt end of
nozzle brush and soap . Wipe ring with clean cloth and
5
sanitizer until it comes away clean.
Rinse with warm water .
Wait two minutes .
Allow to air dry.
Repeat scrubbing and wiping ring
with clean sanitizer .
6 Re-insert
3 Submerge
nozzles
the nozzle
by pushing
in sanitizer
upward and
for two
rotating
minutes .
clockwise .
Agitate to
Pour remaining
2
remove air
sanitizer down the dispenser drain .
pockets .
Allow to air dry.
24
Cleaning ice chute
Turn off power using the green
1
power button .
Using the ice
2
chute brush
and
approved
sanitizer
solution,
clean the
inside of the
chute .
3 Wait two minutes to allow to air dry,
then repeat step 2 with fresh
sanitizer solution .
4 Wipe the outside of the ice chute tip
using a clean cloth and fresh
sanitizer solution .
Allow to air dry before resuming
normal operation .
© 2023 The Coca-Cola Company | Confidential information of The Coca-Cola Company | Coca-Cola Freestyle® 7000 User Guide | V6 230123
COCA-COLA FREESTYLE 7000 | MAINTENANCE
®

Cleaning ice bin

Remove all ice by using
1
the dispense lever
(if a top-mounted ice
maker is installed,
follow manufacturer's
recommendation for
cleaning).
Power off and unplug the
2
dispenser . Remove the
ice bin lid and pour warm
water slowly into the bin
to melt the remaining ice .
© 2023 The Coca-Cola Company | Confidential information of The Coca-Cola Company | Coca-Cola Freestyle® 7000 User Guide | V6 230123
Spray approved sanitizer
3
solution (Kay-5) onto all
internal surfaces of ice
bin and both sides of ice
bin lid . Wipe or scrub
areas within reach inside
the bin with either a clean
cloth or an ice bin brush
(small parts #149322).
Spray approved sanitizer
4
solution on all internal
surfaces and lid again,
allow draining and air
dry. Return to normal
operation .
NOTE: For complete
disassembly instructions,
contact your Coke
representative .
25