Carrier TOSHIBA MMK-UP0151HP-UL Service Manual page 132

Cancelling swing
* Display when swinging (up / down) is cancelle
"Fan", "Heat"
* Display when swinging (up / down) i
cancelled "Cool", "Dry"
1
During swing operation, press [
[ ] to switch to the "Wind direction"
screen
2
Press [ ] or [
The louvres stop at the position when [

or [ ] is pressed.
When [ ] is pressed in the display when

swing was cancelled, the louvres go to wind
direction position (1), when [
the louvres go to position (3) during "Cool" or
"Dry" operation, and go to position (5) during
"Fan" or "Heat" operation.
] and
]
] is pressed,
Group control
In a group control, a remote controller can control
up to maximum 8 or 16 units. (Depending on the
outdoor unit.)
• The wired remote controller only can control a
group control. The wireless remote controller is
unavailable for this control.
• For cabling procedure and cables of the
individual line (Identical refrigerant line) system,
refer to "Electrical connection" in this Manual.
• Cabling between indoor units in a group is
performed in the following procedure.
Connect the indoor units by connecting the
remote controller inter-unit cables from the
remote controller terminal blocks (A, B) of the
indoor unit connected with a remote controller to
the remote controller terminal blocks (A, B) of the
other indoor unit. (Non-polarity)
• For address setup, refer to the Installation
Manual attached to the outdoor unit.
NOTE
Net work adapter (Model TCB-PCNT31TLUL) can
not connect to this High Wall type air conditioner.
Remote controller sensor
]
The temperature sensor of the indoor unit senses
room temperature usually. Set the remote controller
sensor to sense the temperature around the remote
controller.
Select items following the basic operation procedure
1 2 3 4
( → → →
• Specify [32] for the CODE No. in Procedure
• Select the following data for the SET DATA in
4.
Procedure
SET DATA
Remote controller
sensor
When flashes, the remote controller sensor is
defective.
Select the SET DATA [0000] (not used) or replace the
remote controller.
- 132 -
5 6
→ → ).
0000
Not used
(factory default)
3.
0001
Used