Installation of eletrical cover 2 holes type
REQUIREMENT
In case of group control, electrical cover 1 hole type need to change to electrical cover 2 holes type.
● Step to remove the electrical cover 1 hole.
1) The electical cover 1 hole can be removed by removing the screw securing
the electical cover 1 hole and them pulling out the electical cover 1 hole.
2) Remove the electical cover 1 hole by direction backside of unit.
3) Remove the EDGE-SADDLE take off from electical cover 1 hole.
● Step to install the electical cover 1 hole (Option connect power supply 2 holes)
1) ) Install the EDGE-SADDLE to electrical cover 1 hole
2) ) Install the electrical cover 1 hole to unit
Make sure to fix pin
on position lock.
Remove the screw 1 part.
Make sure screw 1 part fix on position.
- 114 -
3) ) Insert the screw.