Heiniger StyleMidi OC20 Instruction Manual page 19

to provide additional protection. Ask your electrician for advice. The installa-
tion should only be carried out by a qualified electrician.
DANGER! Risk of electric shock
The following safety instructions apply to the connected charging station, and
to the appliance when it is being operated with the power supply unit.
Check the appliance and the connecting cable regularly for damage. Do not
use the appliance if the appliance or the connecting cable has any visible
damage, or if the appliance has previously been dropped.
Only connect the power supply unit to a properly installed and easily accessi-
ble power socket, whose voltage corresponds to the specifications on the
type plate. The wall socket must still be easily accessible after the appliance
is plugged in.
Lay the connecting cable such that no one can step on it, get caught on it, or
trip over it.
Please be careful not to damage the connecting cable:
– Keep the connecting cable away from hot surfaces and sharp edges.
– Ensure that the connecting cable cannot be trapped or crushed.
– Do not wrap the connecting cable around the appliance. The cable may
break.
To pull the power supply unit out of the power socket, always pull on the
power supply unit, and never on the connecting cable.
Never attempt to remove dust and foreign objects from inside the appliance
using pointed objects.
Pull the power supply unit out of the power socket, ...
– after every use,
– after each charging process (does not apply to charging station),
– if there is a fault,
– before oiling the appliance,
– before you clean the appliance and
– during thunderstorms.
Ensure that the power supply unit cannot be plugged in again during clean-
ing.
In order to avoid any hazards, do not make modifications to the appliance.
You also must not replace the connecting cable yourself. Repairs must be
carried out exclusively by your authorised customer service centre.
Use only original spare parts, which you can order from the customer service
centre (see the back of these user instructions). If the connecting cable is
damaged or crushed, both it and the power supply unit must be completely
replaced.
WARNING! Risk from batteries
Protect the battery against mechanical damages. Fire hazard!
Do not expose the appliance to direct sunshine or heat. The ambient temper-
ature should not be lower than 0 °C or higher than +40 °C.
The charge contacts on the appliance must not be connected by metallic objects.
Charge the appliance's built-in battery exclusively using the original acces-
sory parts.
The appliance must only be operated with the original
supply unit.
C20 power
ENGLISH 17