Advertisement
Troubleshooting guide
Issues
Display is not
The power plug could be not properly
switched on or not
inserted into its socket.
operational
Ambient and cold
The water supply might be disconnected.
water is not served
The unit was just connected to a power
source.
Dispensed cold water
is not cold enough or
not at desired
temperature
Cold water had been dispensed in large
amounts previously or had been
dispensed frequently.
The hot water is switched off.
Hot water is not hot
enough, or not at
desired temperature.
There is no water in the hot water tank.
Checking points
Page 8 of 10
Actions
Ensure that the power plug is now inserted properly
into its socket.
Ensure that the unit is properly connected to a proper
water source and wait for at least 80min for the
water to cool to desired temperature.
Water is still in the process of cooling down and
being produced. Wait for 2 hours for initial startup.
There is insufficient cold water in the unit and new
water from the source is being cooled down. This
process takes approximately 80 minutes.
Turn on the heating switch.
It takes a few minutes to fill up the tank and heat the
° C
water to 85-95
.
Hide quick links:
Advertisement
