Load Paper - Epson Stylus NX430 Small-in-One Start Manual

5
Lower the scanner unit.
6
Press OK to prime the ink delivery system. Priming takes
about 4 minutes.
Note: Your printer ships with full cartridges and part of the ink from
the first cartridges is used for priming the printer.
Caution: Don't turn off the printer while it is priming or you'll
waste ink.
7
When you see this menu on your product's LCD screen, do
not press any buttons yet. Continue with the instructions in
the following sections.
5

Load paper

1
Flip the feeder guard forward.
2
Raise the paper support, if necessary. Then pull up the
extension and tilt it back slightly.
3
Pull out the output tray, then raise the paper stopper.
4
Slide the edge guide to the left.
5
Load paper against the right edge guide and behind the
tab line on the left edge guide, with the printable side
faceup.
8½ × 11 inch
(216 × 279 mm)
(102 × 152 mm)
Note: Don't load the paper sideways; always load it short
edge first.
6
Slide the edge guide over, against the left edge of
the paper.
7
Flip the feeder guard back.
4 × 6 inch