Epson B-300 User Manual page 48

10. Select the appropriate document type as the Select Document Type setting.
11. Specify the Print Density and Increased Ink Drying Time as the Adjustments setting.
Note:
When you print data with dense photo on both sides of paper, reduce the print density and increase the
drying time to print finely.
12. Click OK to return to the Page Layout window.
13. Click Margins to open the Margins window.
14. Specify the edge of the paper where the binding will be placed. You can choose Left, Top, or
Right.
15. Choose cm or inch as the Unit setting. Then specify the width of the binding margin. You can
enter any width from 0.3 cm to 3.0 cm, or from 0.12 inches to 1.18 inches.
Note:
The actual binding margin may be different from the specified settings depending on your application.
Experiment with a few sheets to examine actual results before printing the entire job.
16. Click OK to return to the Page Layout window. Then click OK to save your settings.
17. Load paper into the printer, then send the print job from your application.
& See "Loading Paper" on page 22.
Note:
Do not pull out the paper with force when the printer ejects paper after printing on one side.
B-300/B-500DN
Printing with Special Layout Options
User's Guide
48